Carrier Strip Tabs With Stainless Steel Connector Terminals and Formed Latch Hooks

301 half-hard and 304 standard grade are the two stainless grades most specified for stainless steel connector terminals with formed latch hooks; 301 half-hard delivers 690–760 MPa tensile strength after forming and provides the elastic spring-back required for latch hook retention force above 5 N in consumer electronics and automotive connectors, while 304 is selected when corrosion resistance in humid environments takes priority over hook spring stiffness. Hook deflection tolerance outside ±0.05 mm changes latching force above or below the design window and causes either failed engagement or permanent hook deformation after repeated connect-disconnect cycles. Dongguan Ruishuo Hardware Electronics (Dongguan, Guangdong, established 2016) stamps this carrier strip stainless steel connector terminal set with formed latch hooks at their an estimated 2,000 m² Dongguan facility, with hook deflection, terminal width, and latch geometry cross-checked with your released dimensions during first-piece sign-off. Typical end markets include aerospace, medical equipment, and automation. Provide material grade, hook deflection tolerance, terminal width, and finish quality and your drawing for quoting. For a stamping price estimate from our dongguan team.